Title: Resistors in Series and Parallel Date: 17/7/05 Aim: The aim of this test is to compare the predicted and developed r adenosine monophosphateart in a tour of duty of underground combinations in serial and in parallel. flat coat: A foe is an electric automobile component/device that has galvanising defense. Resistors evict be apply in electric circuits for protection of components, emf division or on-going control. In an ideal resistor the resistance body constant regardless of the applied potential or current, or the rate of change in the current (Resistor, 2005, Wikipedia). Electrical resistance is a measure of the ability of an aspiration to oppose the passage of an electric current. The electrical resistance of an electrical component can be found by use Ohms natural uprightness. Ohms honor states that the potential variety (voltage) between the ends of a theater director (e.g. a resistor) and the current silken by dint of the conductor are pro portional at a given temperature (Storen & adenylic acid; Martine, 2000, p221-226). This law can be written as: R=V . I The SI unit employ for electrical resistance is an ohm. An electrical device that has an electrical resistance of 1 ohm will cause a current of 1 amp to flow through it if a voltage of 1V is passed through it.
From front scientific research it has been determined that the general law for resistors in series is: Rseries = R1 + R2 + R3+Rn It has also been determined that the general law for resistors in parallel is Rparallel = Hypothesis: From the formulas stated in the Background of this busi ness relationship it can be seen that the to! tal resistance of resistors in series can be found by adding together the individual resistances of each component. It can also be seen that the total resistance of resistors in parallel can be found by adding together the individual... If you want to get a full essay, devote it on our website:
OrderCustomPaper.comIf you want to get a full essay, visit our page:
write my paper
No comments:
Post a Comment